How to Program Key Fob Push Start Dodge Journey
Programming a key fob for push start functionality on a Dodge Journey can be a straightforward process, but it requires following specific steps to ensure that the system recognizes the new key fob. This guide will walk you through the entire process, from gathering the necessary tools to completing the programming sequence. Whether you’re a DIY enthusiast or simply looking to add convenience to your daily routine, here’s everything you need to know about programming your Dodge Journey’s key fob for push start.
Step 1: Gather the Necessary Tools
Before you begin, make sure you have the following items ready:
– A new key fob for your Dodge Journey.
– A flathead screwdriver.
– A set of jumper wires or a universal remote programming tool.
– A pair of gloves (optional, for handling the battery terminals).
Step 2: Locate the Key Fob Programming Terminal
Open the driver’s door of your Dodge Journey and locate the key fob programming terminal. This is typically found on the driver’s side, near the shifter. It’s a small, round connector with a plastic cover that can be pried open with a flathead screwdriver.
Step 3: Connect the Jumper Wires
Take your jumper wires and connect them to the programming terminal. The red wire should be connected to the positive terminal of the battery, and the black wire should be connected to the negative terminal. Make sure the connections are secure to prevent any electrical issues.
Step 4: Turn on the Ignition
With the jumper wires connected, turn on the ignition to the “ON” position. This will put the vehicle’s computer into programming mode.
Step 5: Program the Key Fob
Press and hold the “LOCK” button on the key fob for approximately 15 seconds. You should see the interior lights flash to indicate that the system is ready to program a new key fob.
Step 6: Enter the Programming Sequence
While holding the “LOCK” button, press the “UNLOCK” button on the key fob once. Release both buttons, then press the “LOCK” button again. The interior lights should flash again, indicating that the system is ready to enter the programming sequence.
Step 7: Complete the Programming Sequence
Within 5 seconds, press the “UNLOCK” button on the key fob twice. The interior lights should flash a third time, confirming that the new key fob has been successfully programmed.
Step 8: Disconnect the Jumper Wires
Once the key fob is programmed, disconnect the jumper wires from the battery terminals. Remove the key fob from the programming terminal and replace the plastic cover.
Step 9: Test the Key Fob
Insert the new key fob into the ignition and attempt to start the vehicle. If the push start feature works, you have successfully programmed the key fob for your Dodge Journey.
Conclusion
Programming a key fob for push start functionality on a Dodge Journey can be a simple task when following the correct steps. By gathering the necessary tools and carefully following this guide, you can add convenience to your vehicle without the need for professional assistance. Always refer to your vehicle’s owner’s manual for specific instructions and safety precautions when working with electrical systems.
