How to Adjust Tracking on Scag Walk Behind
Maintaining the proper tracking on your Scag walk behind mower is essential for optimal performance and to ensure a smooth, even cut. Tracking refers to the alignment of the wheels on the mower, and when it’s off, it can lead to uneven grass heights and potential damage to the mower. In this article, we will guide you through the process of adjusting the tracking on your Scag walk behind mower, ensuring that you can keep your lawn looking pristine.
Step 1: Gather the Necessary Tools
Before you begin the tracking adjustment process, gather the necessary tools. You will need a socket set, a wrench, and a measuring tape. It’s also a good idea to have a friend or family member assist you, as some steps require two people.
Step 2: Park the Mower on a Level Surface
Find a flat, level surface to park your Scag walk behind mower. This will ensure that the mower is stable during the adjustment process. Make sure the mower is turned off and the engine is cool before proceeding.
Step 3: Locate the Adjustment Nuts
Identify the adjustment nuts located on the lower part of the wheel hubs. These nuts are typically accessed through a small hole or a cover on the mower frame. You may need to remove a few screws or clips to access them.
Step 4: Loosen the Adjustment Nuts
Using a socket and wrench, gently loosen the adjustment nuts on both sides of the mower. It’s important not to remove them completely; just enough to allow for movement.
Step 5: Adjust the Tracking
With the nuts loosened, gently pull or push on the wheels to adjust the tracking. If the wheels are too far apart, move them closer together, and if they are too close, move them apart. Use the measuring tape to ensure that the distance between the wheels is equal on both sides.
Step 6: Tighten the Adjustment Nuts
Once the tracking is adjusted to the desired position, use the socket and wrench to tighten the adjustment nuts. Make sure they are securely fastened, but do not overtighten them.
Step 7: Test the Mower
After completing the adjustment, it’s essential to test the mower. Turn on the engine and run the mower on a short, level section of your lawn. Observe the grass height and the tracking to ensure that it is even and consistent.
Conclusion
Adjusting the tracking on your Scag walk behind mower is a straightforward process that can be completed in a relatively short amount of time. By following these steps, you can ensure that your mower remains in top condition, providing a professional-looking cut to your lawn. Regularly checking and adjusting the tracking will not only improve the appearance of your yard but also extend the life of your mower.
