How to Build a Pull Behind Tiller
Building a pull behind tiller can be a cost-effective and practical solution for those who need to till their gardens or small plots of land without the use of a motorized tiller. A pull behind tiller is a simple tool that attaches to the rear of a garden tractor or ATV, allowing you to till the soil with ease. In this article, we will guide you through the process of building your own pull behind tiller, from gathering the necessary materials to assembling and using it.
Materials and Tools Needed
Before you begin building your pull behind tiller, you will need to gather the following materials and tools:
– 2×4 lumber (for the frame)
– 1×2 lumber (for the tines)
– 3/8″ bolts, nuts, and washers (for the tines and frame)
– 1/2″ bolts, nuts, and washers (for the frame)
– 2 1/2″ carriage bolts (for the tine mounting)
– 2 1/2″ washers (for the tine mounting)
– 2 1/2″ nuts (for the tine mounting)
– 2 1/2″ lock washers (for the tine mounting)
– 1/2″ flat washers (for the frame)
– 1/2″ nuts (for the frame)
– 1/2″ lock washers (for the frame)
– 1/2″ bolts (for the frame)
– 1/2″ nuts (for the frame)
– 1/2″ lock washers (for the frame)
– Angle iron (for the frame)
– Welding rod (for welding the frame)
– Welding gloves and mask (for safety)
– Drill and drill bits
– Saw (hand saw or circular saw)
– Hammer
– Wrench
– Pliers
– Tape measure
– Square
Step-by-Step Instructions
1.
Design the Tiller
Begin by sketching out a design for your pull behind tiller. Determine the size of the tines and the overall length of the tiller. Keep in mind that the tiller should be long enough to cover the width of your garden or plot, but not too long to be difficult to maneuver.
2.
Construct the Frame
Cut the 2×4 lumber to the desired length for the frame. Using the saw, create the frame by joining the pieces together with the 1/2″ bolts, nuts, and washers. Ensure that the frame is square and level.
3.
Attach the Tines
Cut the 1×2 lumber to the desired length for the tines. Attach the tines to the frame using the 3/8″ bolts, nuts, and washers. The tines should be positioned at a 45-degree angle to the ground for optimal tilling.
4.
Weld the Frame
Weld the frame together using the welding rod and welding gloves and mask for safety. Ensure that the frame is securely attached and that the tines are properly aligned.
5.
Mount the Tiller to the Tractor or ATV
Attach the tiller to the rear of your garden tractor or ATV using the carriage bolts, washers, nuts, and lock washers. Ensure that the tiller is securely mounted and that the tines are aligned with the ground.
6.
Test the Tiller
Before using the tiller, it is important to test it out. Attach the tiller to your tractor or ATV and take it for a test run. Make sure that the tiller is working properly and that the tines are tilling the soil as expected.
7.
Use and Maintain the Tiller
Once you have tested the tiller and are satisfied with its performance, you can use it to till your garden or plot of land. Remember to maintain the tiller by cleaning it after each use and inspecting it for any signs of wear or damage.
Building a pull behind tiller can be a rewarding project that provides you with a practical tool for tilling your garden or small plot of land. By following these steps and using the necessary materials and tools, you can create a durable and efficient tiller that will serve you well for years to come.
